لودسل فشاری BCS compression load cells - CNX

شرکت ایده و فرآیند آریو: ۰۲۱۸۸۳۲۰۹۲۹ - ۰۲۱۸۸۳۲۰۹۲۸

لودسل های فشاری مدل CNX - شرکت بی سی اس ایتالیا، جزوه لودسل های با کیفیت و با دوام می باشند که معمولا در صنعت فولاد سازی و برای سیستم های توزین قراضه و پاتیل استفاده می گردند. شرکت ایده و فرآیند آریو، ضمن آشنایی با تجهیزات شرکت BCS ایتالیا، امکان تامین تجهیزات برند مورد اشاره را با کمترین زمان تحویل را دارد. compression load cell Compression load cells can be used for oscillating mounting systems (or sliding bearing) or with double spherical shells and hardened dowels. Compression load cells can be empoyed in mounting systems (or sliding ball bearing) or with double spherical head and hardened blocks. BCS compression load cells series CN is very compact, rugged transducers, without movable parts, suitable to convert supported forces or weights into a proportional electric signal. Load cells consist of an elastic mechanical element in high tensile steel withstanding the load, activated by means of a full strain-gauges bridge. Proper and accurate thermal compensation for zero coefficient and elastic module of the supporting element steel allows measuring strain and weights in a wide room temperature range, with reliability, high accuracy and repeatability over the short and long term. Each load cell is calibrated for an output signal of 2,000 mV/V at nominal rated load applied: this allows complete interchangeability among load cells, without any calibration adjustment for the connected measuring instrument. Each cell is closed into a waterproof case and is provided with 5 m of six-wire shielded cable, directly fastened to the case (for some applications, a special cable for a high-temperature environment is available). On request, the cable can be replaced by a 6-pin connector. Load cells series CN has been specifically designed to cope with side loads, and are provided with a double spherical head, which allows moderate slope of load cell with inherent small side loads and assures the settlement in a vertical position when the sideload falls; the use of relevant mounting accessories (hardened steel pads and mounting plates) is recommended. The following nominal capacities are available: 6 - 10 - 15 - 20 - 30 - 50 - 100 - 150 - 200 tons; on request, load cells with other capacity values can be manufactured.